Laser 3799 Spline Bit Set M14 2pc
- Brand: Unbranded
Description
With piston still protruding fit the dust seal, a little red grease helps push it in the recess. Once in secure with the metal ring, easiest to keep the open end of the ring away from the bridge of the caliper. This often the hardest part as you need to push the ring into the recess, which is allows a fight as you try not to puncture the dust seal. Once seated pull the dust cover out so the outer end fits into the recess on the piston. Move the piston in and out to ensure the dust cover stays in place. I see that Irwin do some removers for this. Anyone used them with success pls,or know any other way. I used wd40 before trying but it's an absolute ****
4147 Ball Joint Spline Bit M14 - for VAG - Laser Tools 4147 Ball Joint Spline Bit M14 - for VAG - Laser Tools
An arc will be in the 2000C range, so you only need a couple of seconds to get a bolt red hot. A blowtorch at around 700C will take ages to do the same. All the while heat is escaping to do naughty things elsewhere. Once seal and piston are fitted and ready to be rewound fully into the caliper, either use a proper tool or improvise with wide pipe grips to grip the very end of the piston and rotate bit by bit to screw it in.What's it like doing the rear discs on a mk3? On the mk2 it was a bloody nightmare as there was hardly any access to get at the caliper bolts. They are tightened by first a torque then a further angle to stretch them. (Like 70nm + 90degrees) it is what stops them undoing and they are single use. It says under each of these torque settings in the manual “replace after each removal”
Spline Sets | Spline Socket Bit Sets | Euro Car Parts
Hi Aj77, I had done much research on-line and found that most mechanics report that they always reuse these bolts. If you have access to an air tool, these carrier bolts do come out easilly. I'm pleased that I managed it with limited facilities and I did clean the threads and reused the bolts with a little blue Loctite on the threads and tightened them using a torque wrench. This was a simple but prolonged job which took me a week of daily spraying K2 Vulcan penetrating oil, My biggest worry was if the splines stripped, what do I do then, so I will keep your method in mind for when I do my own Octavia in the summer.Manufacturer -Neilsen. Size - M14. 2pc Spline Bit Set. 10mm Hex drive. Dispatch will normally be within 24 hours of funds clearing. S2 steel construction. One piece design.
- Fruugo ID: 258392218-563234582
- EAN: 764486781913
-
Sold by: Fruugo